Rev. 00 03/19
48
Operation OptiStar 4.0 (CG24-CP)
Correction values
With the correction values, the gun control unit can be adapted optimally
to local conditions (e.g. the adjustment of different powder outputs in the
plant).
Incorrectly set correction values can lead to damage to the
Application pump
The plant was optimally set by the Gema service engineer at the
first start-up.
► Changes of correction values may only be made by Gema trained
personnel.
Entering the correction values
1. Hold the key down for 5 seconds
– The display switches to the following level:
2. Press the key
– The display switches to the following level:
To Next Page
Loading...
