Rev. 00 03/19
50
Operation OptiStar 4.0 (CG24-CP)
7. Press the key
– The display returns to the first level display.
Cleaning mode
The cleaning mode enables blowing off powder accumulations in the
powder hose with preset air pressure, and is activated via the CAN bus –
see the CM30 operating instructions.
Activating the cleaning function
The cleaning mode can only be activated from standby mode (main menu
display, no powder conveying). The prerequisite is, that all necessary
release signals are present.
Setting the background illumination
1. Press the key
The display switches to the following level:
2.
Select the desired brightness
To Next Page
Loading...
