Rev. 00 03/19
22
Product description OptiStar 4.0 (CG24-CP)
Scope of delivery
– Power cable (country-specific)
– Quick-start guide and operating manual
Typical properties – Characteristics of the functions
Operating modes
The gun control unit has two operating modes.
Predefined operating mode (Preset mode)
The gun control unit has three preset application modes:
Fig.
Application mode for flat parts
This application mode is suitable for the coating of simple, flat
workpieces without larger cavities.
Application mode for complicated parts
This application mode is suitable for the coating of three-
dimensional workpieces with complex shapes (e.g. profiles).
Application mode for recoating parts already coated
This application mode is suitable for the overcoating of
workpieces which are already coated.
In this operating modes, current (µA) and high voltage (kV) are preset,
while powder and air volumes can be set and stored for each application
mode.
To Next Page
Loading...
