Gema OptiStar 4.0 - CAN Bus and Network Setup

Rev. 00 03/19
OptiStar 4.0 (CG24-CP) Start-up

37
CAN bus
General
The control unit is a simple CANopen slave. It operates in a network with
a central control unit (Master). Communication takes place exclusively
between the Master and the Slaves.
Following data can be accessed by CANopen:
– All desired values (process data)
– All actual values (process data)
– All control values
– All system parameters (except Baud rate and CAN address)
– All error messages
– All special parameters such as software version, daily correction,
powder output correction etc.