29 Failure to follow these warnings can result in serious personal injury or death.
30 2.9 Housing
31 2.10 Component Overview
32 2.11 Label Overvi
33 3 Installation
34 WARNING!
35 NOTICE
36 3.2 Reviewing Shipment and Identifying Product Model
37 3.3 Product Installation Check List
38 Mounting
39 3.4 Mounting
40 3.4.1 Sensor Mounting Location
41 3.4.2 Transmitter Mounting Location
42 3.4.3 Sensor Orientation WARNING!
43 WARNING!
44 3.4.4 Connecting Sensor to Transmitter Housing or Remote Junction Box
45 To connect the sensor:
46 3.4.5 Integrated Mounting Points
47 Mounting Points JB5000 Junction Box
48 3.4.6 Adjustable Pipe Mount
49 3.4.7 Duct Mount
50 NOTICE
51 NOTICE
52 3.4.8 Mounting with a Sunshield
53 3.4.9 Mounting with an SM5000 Sampling Module
54 3.5 Installing a Remote Sensor Junction Box
55 3.6 Electrical Power Connections
56 WARNING!
57 3.6.2 Retrofit Applications with S4000CH, S4000TH, or TS4000H
58 3.6.3 Electrical Hardware Requirements
59 3.6.4 Power Load Requirements and Maximum Mounting Distances
60 3.6.5 Instructions for Power and Analog Output
61 S5000 Installation Outline Drawings
62 3.6.6 Relay Electrical and Power Connections
63 Relay Specifications
64 Relay Connections to Inductive Loads
65 Fault Relay Wiring and Configurations
66 Relay Energy State and Terminal Connections
67 4 Operation
68 4.1 Startup
69 4.1.2 Sensor Warm Up Times
70 WARNING!
71 4.1.3 Startup after Power Failure
72 4.2 Settings
73 Changing a value
74 4.2.1 Instrument Settings
75 4.2.2 Sensor Setup
76 Disable Sensor (for Digital Sensors Only)
77 Gas Label and Unit
78 Cal Level (i.e. Span Value)
79 Warning Settings
80 Alarm Settings
81 Diffusion Supervision
82 To enable or disable Diffusion Supervision:
83 Sensor Reset – Last option in Sensor Setup
84 4.2.3 Relay Settings
85 Relay Zone/Mapping
86 Energized/De-energized
87 Enable/Disable HART
88 4.2.5 HART AO
89 4.2.6 Calibration Alert
90 To Enable or Disable Calibration Alert:
91 Bluetooth Pairing
92 Bluetooth Security
93 To reset all device pairings:
94 Bluetooth Tag ID
95 Modbus Address
96 4.2.10Swap Delay
97 To change Swap Delay status:
98 4.2.11UI Password Enable/Change Password
99 Enter Password (if password is enabled)
100 4.2.12Transmitter Setting Reset
101 4.3.1 AO Type
102 4.3.2 View or Change System Time
103 4.3.3 Last Calibration
104 4.3.4 Non-Critical Fault Log
105 4.3.5 Device Tag
106 4.3.6 Bluetooth FCC/IC ID
107 4.3.7 Sensor Life and Health Status (only displayed if XCell Sensor is connected)
108 4.4 Setting only configurable via Bluetooth®, Modbus, or HART
109 4.4.1 AO Custom Levels
110 4.4.2 Relay Zone – Horn Mode
To Next Page
Loading...
Need help?
General