General Monitors S5000 User Manual

110 4.4.2 Relay Zone – Horn Mode
111 4.4.3 Unit Device ID/Tag
112 4.4.5 Alarm Enable/Disable
113 5 Calibration
114 WARNING!
115 Failure to follow this warning can result in serious personal injury or death.
116 5.2 Calibration Frequency
117 5.3 Calibration Frequency for XCell Sensors with TruCal (H2S & CO only)
118 WARNING!
119 Failure to follow this warning can result in serious personal injury or death.
120 5.5 How to Zero Calibrate XCell and IR Sensors
121 WARNING!
122 WARNING!
123 To calibrate the sensor:
124 5.7 How to Calibrate an Oxygen XCell Sensor
125 5.9 How to Calibrate a Passive Sensor (Catalytic Bead or MOS)
126 To calibrate sensor:
127 5.10 XCell Catalytic Bead Failsafe
128 WARNING!
129 5.11 Calibration Confirmation
130 6 Maintenance
131 WARNING!
132 6.1 IR Sensor Cleaning Procedure
133 WARNING!
134 6.2 Replacing an XCell Sensor
135 WARNING!
136 6.3 Clearing a Blockage
137 6.4 Replacing a Passive Sensor (Cat Bead or MOS)
138 To replace the passive sensors:
139 6.5 Troubleshooting
140 7 Ordering Information
141 WARNING!
142 8 Appendix: Specifications
143 9 Appendix: General Certification Information
144 S5000 Transmitter, Junction Box, and JB5000 Junction Box
145 WARNING!
146 The following information shall be noted for FM Approved configurations:
147 WARNING!
148 Specific Conditions of Use S5000 Transmitter
149 S5000 Junction Box
150 Digital Sensor
151 10 Appendix: HART Specific Information
152 Read More About This Manual & Download PDF:
153 Related Manuals
General Monitors S5000 Gas Monitor User Manual

General Monitors S5000 Specifications

General

Sensor Type	Electrochemical
Gas Detected	Oxygen, Toxic and Combustible Gases
Enclosure	Stainless Steel
Certifications	ATEX, IECEx, UL, CSA
Detection Principle	Electrochemical, Infrared
Enclosure Rating	IP66
Power	12-30 VDC