WP21 Series Operation Manual Chapter 6 Software Operation
47
Wavelength
Operation: Use left and right cursor keys to choose
Options: 340nm, 380nm, 405 nm, 505 nm, 546 nm, 578 nm,
620 nm
Sampling points
Operation: Use left and right cursor keys to choose
Note: The setting range of the kinetic [K] method is 3 – 9.
Normal values
Operation: After selecting this parameter, press the number
key “1” to set the value.
Correction
Operation: After selecting this parameter, press the number
key “1” to set the value.
Calibration
Operation: Use left and right cursor keys to choose
Options: Single-point linear, two-point linear, multiple-point
non-linear, not calibration
Linear range
Operation: Choose “>” or “<” using left and right cursor keys
and press the number key “1” to set the value.
Delay time
Operation: Press the number key “1” to set the value.
To Next Page