Weld334m - User’s manual
1
1.
Safety
To insure correct installation and operation of the WELD334m welding control device, it is
necessary to carefully read this chapter. Each operation on the machine is to be carried out
only by qualified personnel with good understanding of the information contained in this
manual; should the documentation not be perfectly legible and/or incomplete of any further
information required, please consult GF WELDING S.p.A. before undertaking any work on
the machine.
Inside the welding control, signals are generated which set parts of the machine in motion;
therefore, it is prohibited to open and tamper with the control and safety circuits. Live
metal parts, such as screws or similar parts, penetrating into the electric circuit may cause
malfunctioning as well as the generation of incorrect and hazardous conditions and events.
It should be remembered that any changes and/or modifications not expressly authorised
by the manufacturer or performed by unauthorised personnel or non-GF WELDING
personnel which modifies the machine operation makes the warranty void.
Check all cables and the relevant connections before using the welding control device in
order to see if there is any mechanical damage or failing insulation. Whenever a problem
arises such as to compromise the safety conditions, switch off the unit and cut out power.
Report the problem to GF WELDING
After Sales
Personnel
.
To ensure the optimal performance of the device, the user must make sure that all
requirements for safety on the work site are strictly adhere to.
To Next Page
Loading...