your safety, and the safety of others, to understand the procedures before beginning work.
Follow the Regulations
There is applicable information in Occupational Safety and Health regulations, and national, state, and local
codes, which must be followed. Failure to install, inspect, maintain, or service this equipment in accordance
with these codes, regulations, and standards may lead to legal citations with penalties, or affect the safe use
and operation of the equipment.
Replacement Parts
Use only genuine Orpak replacement parts and retrofit kits in your installation. Using parts other than
genuine Orpak replacement parts could create a safety hazard and violate local regulations. Repair should
only be done by authorized personnel certified by Orpak.
Only Suitably certified and rated SELV and LPS external power supply may be connected to the terminal unit.
Prevent Explosions and Fires
Fuels and their vapors will become explosive if ignited. Spilled or leaking fuels cause vapors. Even filling
customer tanks will cause explosive vapors in the vicinity of dispenser or island.
Warning: Do not open the unit when an explosive atmosphere is present.
Caution: Batteries are not replaceable. Replaceable batteries — Risk of explosion if battery is
replaced by an incorrect type. Dispose of used batteries according to the instructions.
Attention: Les batteries ne sont pas remplaçables. Batteries remplaçables — Risque
d'explosion si la batterie est remplacée par un type incorrect. Mettre au rebut les batteries
usagées selon les instructions.
No Open Flames
Open flames from matches, lighters, welding torches, or other sources can ignite fuels and their vapors.
No Sparks - No Smoking
Sparks from starting vehicles, starting or using power tools, burning cigarettes, cigars or pipes can also ignite
fuels and their vapors. Static electricity, including an electrostatic charge on your body, can cause a spark
sufficient to ignite fuels and their vapors. After getting out of a vehicle, touch the metal of your vehicle to
discharge any electrostatic charge before you approach the dispenser island.
Working Alone
It is highly recommended that someone who is capable of rendering first aid be present during servicing. Be
familiar with Cardiopulmonary Resuscitation (CPR) methods if you are working with or around high voltages.
This information is available from the Red Cross. Always advise the station personnel about where you will
be working, and caution them not to activate power while you are working on the equipment. Use the OSHA
Lock-Out and Tag-Out procedures.
Working With Electricity Safely
Be sure to use safe and established practices in working with electrical devices. Poorly wired devices may
cause a fire, explosion, or electrical shock. Be sure grounding connections are properly made. Make sure
that sealing devices and compounds are in place. Be sure not to pinch wires when replacing covers. Follow
OSHA Lock-Out and Tag-Out requirements. Station employees and service contractors need to understand
19 OrPAY1000 Installation and Setup Manual
To Next Page
Loading...
Need help?
General
