Section 6 Maintenance
6.1. General
The following provides basic maintenance instructions for the OrPAY1000.
When properly installed and maintained your terminal will provide many years of service. There are few
moving parts and minimal connections, and all parts have been designed to give a good service life.
6.2. Cleaning
Please follow these tips to keep the OrPAY1000 clean:
Use a soft cloth dampened with water for daily cleaning
If grime builds up, use a diluted mild detergent on a soft cloth
Take extra care when cleaning the display window – make sure the cloth is clean and clean the
window before using the cloth on other parts of the terminal
Caution: Do NOT use petroleum-based solvent cleaners as they may damage surfaces
making the terminal much harder to clean and shorten the life of the parts.
Caution: Do NOT use a high-pressure hose to clean the terminal.
6.3. Removal and Reinstallation
6.3.1. Removal
To remove the OrPAY1000, proceed as follows:
1. Ensure the terminal is not being used by a customer
2. Open the pump / pedestal door
3. Switch off the mains power to the power supply
4. Unplug the LAN cable and the low-voltage power cable and any other connected cable (e.g. pump
connection) from the OrPAY1000. Remove the ground wire
5. Loosen and remove the screws holding the OrPAY1000 to the surface / pedestal door. There will
be 4 screws around the outside of the rear plastic
6. Gently hold the OrPAY1000 off the surface / pedestal door, while holding the terminal on the
outside to prevent it from falling
7. Place the OrPAY1000 into suitable packaging for transport or perform the necessary maintenance
71 OrPAY1000 Installation and Setup Manual
To Next Page
Loading...
Need help?
General
