4-8
USER HANDBOOK
The ‘BAT FAULT’ warning ashes when approximately
3 minutes operating time remains, as illustrated in Fig. 4-6.
The display will be red, the audible alarm sounds continuously
and the red LED’s remain on. After 3 minutes, the instrument
automatically switches off.
Fig. 4-6 Exhausted Battery Warning
4.5.2 Zero Fault
A “ZERO FAULT” warning and a ashing spanner symbol
appears after warm-up if the instrument is switched on in the
presence of gas or the instrument has been unable to zero
all sensors correctly.
The screen backlighting illuminates red, the audible alarm
sounds once every 2 seconds and the red LED’s ash.
It is strongly recommended the instrument is returned
to a gas free area. Switch the instrument OFF and then
switch ON again in fresh air. If the fault persists, return the
instrument to a GMI approved Service / Repair facility.
The instrument can however still be used to detect and alarm
on the other sensor(s) tted. Press the Right Hand (RH)
button , as per the screen prompt, to continue.
To Next Page
Loading...
Need help?
General
