GMI PS241 - 5.2.1 Replace Sensor Hydrophobic Filter

5-2
USER HANDBOOK
5.2.1 Replace Sensor Hydrophobic Filter
1. Using a No.1 Pozidrive
®
screwdriver, unscrew the captive
screw and remove the lter cover by sliding it away from
the display screen to disengage the locating lugs from
the corresponding slots in the lter recess.
LOCATING PEGS (2)
LOCATING SLOTS (2)
CAPTIVE SCREW LOCATING LUGS
HYDROPHOBIC
FILTER
(Part No. 64254)
FILTER COVER
ASSEMBLY
(Part No. 64240)
Fig. 5-1 Replace Sensor Filter
2. Carefully lift then remove the hydrophobic lter from the
instrument lter recess.
Note the locating pegs in the instrument lter recess and
mating pin-holes in the hydrophobic lter. Ensure correct
orientation of lter during assembly.