4-11
ALARMS
Fig. 4-10 Check Fault
4.5.4 Flow Fault (Pumped Instruments Only)
If a ow fail or sample fault exists, a ‘FLOW FAULT’ warning
is displayed, as illustrated in Fig. 4-11. The display will be red
and both the audible alarm and red LED’s will be activated.
Check sample line, lter or probe for blockage, if applicable.
Clear the blockage then restart the pump by a press and hold
of the Right Hand (RH) button .
Fig. 4-11 Flow Fault
To Next Page
Loading...
