Driving Instructions
3A3393C Operation 19
Driving Instructions
Perform startup see, Setup/Startup, page 10.
Use the handle bars of the LineStriper to control all
motion during operation. In addition to steering the
LineStriper, the handle bars also control forward and
reverse movement by pulling the forward/reverse
control lever.
NOTE: Make sure wheel motor bypass valve is
engaged (see page 20).
To move forward: Disengage brake and slowly pull
control lever on right side of handlebar.
To move in reverse: Slowly pull control lever on left
side of handlebar.
To stop: Release control lever and allow it to return to
center.
To turn right and left: Turn the handle bar right or left
to steer the LineStriper.
To Next Page
Loading...
