Graco XP70 Instructions

Setup
3A0420V 21
Wire Systems with
Explosion-Proof Heaters
(Hazardous location systems only)
When explosion-proof heaters are used, ensure the wir-
ing, wiring connections, switches, and electrical distribu-
tion panel all meet flame-proof (explosion-proof)
requirements.
Refer to the Viscon HP heater manual for electrical con-
nection instructions and guidelines in hazardous loca-
tions.
If your system is rated for hazardous areas, and you
have explosion-proof heaters, you must have a quali-
fied electrician connect heater wiring. Ensure wiring
and installation comply with local electrical codes for
hazardous areas.
Improperly installed or connected equipment will cre-
ate a hazardous condition and cause fire, explosion,
or electric shock. Follow local regulations.

Graco XP70 Specifications

General

Fluid Output	2.0 gpm (7.6 lpm)
Fluid Delivery	2.0 gpm (7.6 lpm)
Maximum Fluid Working Pressure	7250 psi (500 bar)
Maximum Air Input Pressure	100 psi (7 bar)
Fluid Outlet Size	3/8 in npsm(m)
Wetted Parts	Stainless Steel, PTFE, UHMWPE
Maximum Pressure	7250 psi (500 bar, 50 MPa)
Hose Length	50 ft