P a g e | 51
GDS3705 User Manual
Version 1.0.1.16
Enter the web relay password.
This option allows to choose to use Alarm_Out (COM1) interface for either
as alarm out with 3
rd
party device, or to control a second door “Door 2”
(the two functions are mutual exclusive).
When option “Open Door” is selected, will enable GDS3705 to control the
operation of two doors via RFID, local and remote PINs.
Select Normal Open or Normal Close depending on the lock used.
Device will open door after specified delay (in seconds) when user issuing
the authorization.
Configures the lock holding time, in seconds (default value is 5 seconds).
Device will hold the door unlocked for this specified duration.
Range: 1-1800 seconds.
Minimum Interval of
Swiping Card (ms)
Defines the interval in ms to swipe consecutive RFID cards. The range
should be between 0ms and 2000ms. Default 300 ms.
Chooses whether to make call to the SIP number or Virtual Number when
dialing from the GDS3705 keypad.
Configures the action to be taken when the doorbell is pressed, three
options are available:
Call Doorbell Number: when Doorbell is pressed, a call will be
made to the “Number Called When Door Bell Pressed”.
*This option will be the only available when ALMOUT1 Feature is set to
Open Door.
Control Doorbell Output (Digital Output 1): when Door Bell is
pressed electronic lock for Output 1 is opened.
Both of Above: When selected, both Call Doorbell Number and
Control Doorbell Output options are enabled.
Doorbell Call Out Account
This option sets the account to be used to make call upon the
doorbell trigger. If set to Auto, the GDS will use the first available account.
Select the ring strategy for the Numbers Called when pressing the Door
Bell button to be either Serial or Parallel:
Serial Hunting: the configured extensions and/or IP addresses
will ring one after one by order.
To Next Page
Loading...
Need help?
General
