P a g e | 69
GDS3705 User Manual
Version 1.0.1.16
Table 11: Basic Settings
Selects DHCP or Static IP. Default DHCP. (Static recommended)
Configures the Static IP of the GDS3705.
Configures the Associated Subnet Mask.
Configures the Gateway IP address.
Specifies the DNS type used: Dynamic DNS or Static DNS.
Configures DNS Server 1 IP address.
Configures DNS Server 2 IP address.
Controls the LLDP (Link Layer Discovery Protocol) service. The default
setting is “Enabled”.
Controls the VLAN. Default setting is “Disabled”
Layer 2 QoS
802.1Q/VLAN Tag
Assigns the VLAN Tag of the Layer 2 QoS packets.
Valid range: 0-4096. Default value is 0.
Layer 2 QoS 802.1p
Priority Value
Assigns the priority value of the Layer2 QoS packets. Default value is 0.
Notes:
If the GDS3705 is behind SOHO (Small Office Home Office) router with port forwarding configured
for remote access, static IP should be used to avoid IP address changes after router reboot.
TCP port above 5000 is suggested to Port forward HTTP for remote access, due to some ISP would
block port 80 for inbound traffic. For example, change the default HTTP port from 80 to 8088, to
make sure the TCP port will not be blocked.
OpenVPN® Settings
This page allows users to configure OpenVPN settings.