P a g e | 16
GDS3705 User Manual
Version 1.0.1.16
Firmware Version 1.0.0.35
Added option to assign a schedule to the doorbell. [Press Doorbell Schedule]
Added option to set the maximum number of digits dialed. [Maximum Number of Dialed Digits]
Added support for Parallel Hunting when doorbell pressed. [Door Bell Call Mode]
Added firmware check status button. [Firmware Status]
Added Account section. [Account]
Enhanced Event Notification Template Variables. [Event Notification]
Added Random Port option. [Use Random Port]
Added NAT Traversal option. [NAT Traversal]
Added Doorbell Call Out Account. [Doorbell Call Out Account]
Add ability to set schedule for Alarm IN door opening. [Input Digit]
Added Account Status section. [Account Status]
Firmware Version 1.0.0.31
Added “Enabled but Not Forced; Enabled and Forced” under SRTP Configuration. [Enable SRTP]
Firmware Version 1.0.0.28
Added alarm notification of non-scheduled access users. [Non-Scheduled Access Alarm]
Added support for HTTP command to Open Door [Enable HTTP API Remote Open Door]
Added Keep Door Open section. [Keep Door Open]
Added "Test" Button for Alarm Action. [Alarm Config]
Firmware Version 1.0.0.26
Added displaying logs at device Web UI. [Event Log]
Added ability to upload Trusted CA certificate files. [Trusted CA certificate ]
Added option to enable/disable certificate validation. [Validate Server Certificate]
Added Ability to configure Start/End Valid date for users. [Card Management]
Changed password recovery email option to user settings page. [User Management]
Added UI showing Temperature/TamperSensor/DoorControl/DI/DO in the System Info Page
[System Info]
Added Support for system events notification via HTTP. [Event Notification]
Added Factory Functions for Audio Loopback and Certificate Verification. [Factory Functions]
Firmware Version 1.0.0.20
This is the initial version for GDS3705.
To Next Page
Loading...
Need help?
General
