GRAPHTEC CE7000-60 - Copy (Duplicate Cutting); When Media Change Mode Is off

4-10
4.2
Copy (Duplicate Cutting)
The function to cut specied numbers of cutting data stored in the buffer memory is called COPY.
Supplement
•
Do not send new data to plotter while copying. Cutting data in the buffer memory will be cleared.
•
Previous cutting data will be cleared and newly sent data will be stored as cutting data if you send new data with 10 seconds or more
interval from the time it nished cutting.
•
It can not copy if data is more than 1.6 MB because it cannot be stored in the buffer memory of the plotter.
•
Buffer memory that can be used for copy will decrease if you turn on the data sort. Turn off the data sort when you need to copy
cutting with large data. See "Sorting the Cutting Data" for data sort.
•
Watch out that it does not fall out of media when cutting with copy function.
•
If the original cutting data to be copied starts away from the origin point, copied cutting will also start away from the origin point.
Toavoid wasted space, create the cutting data close to the origin point.
•
When copying using a roll paper barcode, be sure to sacan the bar code on the the leading edge.
When media change mode is OFF
Copy is performed in following order.
Origin point
First cut
Copy origin point
First copy
Second copy
Copy space
Copy
space
Fourth copy
Third copy
It will copy in following order when MIRROR is set.
Origin point
First cut
Copy origin point
Second copy
First copy
Copy space
Copy
space
Fourth copy
Third copy