GRAPHTEC CE7000-60 - 9.3 I;F (LAN)

9-5
9.3
I/F (LAN)
Set the network interface (LAN).
Supplement
When you change the settings of the network, the plotter is reset.
To connect through a network (LAN), it is necessary to set the following items.
•
Set the DHCP
•
Set the IP address
•
Set the subnet mask
•
Set the gateway
•
Display the MAC address
Setting the DHCP
HCP settings depend on the conguration of network equipment and the customer’s environment. For details,
please see the equipment manual, or consult the network administrator.
The default setting of DHCP is OFF.
Operation
Supplement
Perform the settings in Normal mode.
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the POSITION ( ) key (I/F).
INTERFACE screen (1/3) is displayed.