GRAPHTEC CE7000-60 - Adjust the Blade Length Manually

2-55
Adjust the blade length manually
Optimal cut is not achieved unless the blade length is adjusted in accordance to the used media and the cutter blade.
Perform further adjustment by performing cutting test after adjusting the blade length manually.
CAUTION
•
To avoid bodily injury, handle cutter blades with care.
•
It may result to damaging the cutter blade or the cutting mat if the blade is extended too much. Make sure the blade length is set
less than the thickness of the media.
Supplement
•
See "Running Cutting Tests" for cutting tests.
•
When a thin media such as a lm is used, use the supplied magnier to adjust it.
Operation
1
Align the blade tip to the tip of the cutter pen, and make it
touch the surface of the media.
Media
Blade
Supplement
•
Blade length can be changed by spinning
the adjustor on the blade. Spinning it in the A
direction pushes it out, while spinning it in the
B direction pulls it in. One scale unit is equal
to 0.1 mm.
Cutter blade moves approximately
0.1 mm turning one scale unit.
Scale
Scale
•
Guideline to Set the Blade Length
See "Setting the Tool Condition" for the
thickness of the media.
2
Extend the blade little by little to the thickness of the media.
Optimal blade length is less than the thickness of lm and
backing sheet combined, but more than the thickness of the
lm.
Try cutting the lm, and adjust so there is slight cutting on
the backing sheet. If the backing sheet gets cut completely,
reduce the blade length, and if the lm does not get cut
completely, increase the blade length.
Backing Sheet
Film
Optimal blade length
Thickness of Media
Backing Sheet
Optimal
blade length
Film
Thickness of Media