2-6
Supplement
When using with half cutting and plotter pen, set
the seal in Tool Holder (backward), and when
using cutting out (perforated cut), set the seal in
Tool Holder (forward).
2
While pushing up the tool holder, push until its ange
completely touches the upper part of the holder.
Flange
Bracket to hold tool
Tool holder
(Backward: Half cutting/Plotting Pen)
Tool holder
(Forward: Using cutting)
Tool holder
Seen from above
3
Make sure that the bracket is engaged on the tool's ange,
and then tighten the screw.
FlangeBracket to hold tool
Removing the tool
When removing the tool, turn it counterclockwise to remove the tool.
To Next Page
