GRAPHTEC CE7000-60 - Loading the Medium; Effective Cutting Area

2-22
Loading the Medium
How to load a medium with a width of less than 297mm
1
Peel off the separator (yellow) from the carrier sheet to
expose the adhesive surface. (Do not discard the separator,
as it will be used again when the carrier sheet is returned to
its package for storage.)
Carrier sheet
Pell off the separator
Separator (yellow)
Supplement
•
Do not use media that is smaller than
postcard size.
•
When afxing the medium, take care not to
cause any air bubbles or creases.
2
Afx the medium for cutting to the adhesive surface of the
carrier sheet, making sure that the edges of the medium are
parallel with those of the carrier sheet.
Carrier sheet
Medium
Adhesive surface
Effective Cutting Area
Supplement
•
Do not use media that is smaller than
postcard size.
•
The cutting plotter recognizes the width of the
carrier sheet as the cutting area. Be sure to
load a medium that is the same size as the
media setting that was made in the application
software.
•
Be sure to use the (ORIGIN) key to specify
the start position of the cutting operation.
1
The effective cutting area on the carrier sheet is shown in
the diagram below. When loading a medium that is smaller
than A3 size in the cutting plotter, be sure to afx it within the
cutting area (the adhesive surface). Moreover, make sure
that the edges of the medium are parallel with the edges of
the carrier sheet.
Media
Carrier sheetCutting area (Adhesive surface)
Wider space sideNarrow space side
420 mm
297 mm