GRAPHTEC CE7000-60 - Positioning of the Media and the Registration Mark; Cutting Area When Adjusting the Regisitaration Mark

5-6
Positioning of the media and the registration mark
Place the registration mark away from the edge of media to scan the registration mark.
Make sure the push roller location is outside of the registration mark.
Draw the registration mark as shown in the next image.
MARK TYPE 2MARK TYPE 11
15 * 35
17 37
Rightmost push
roller
Rightmost push
roller
Leftmost push
roller
Leftmost push
roller
Unit: mm
* When the expand limit is set to 1
or more, it will be 10.
Cutting area (same as the area after scanning the registration mark)
15 1515 15
Feed direction of media Feed direction of media
Cutting area when adjusting the regisitaration mark
Supplement
If the distortion due to the adjustment is large,
there is a possibility that the cutting area is
reduced.
Even when the registration marks are being adjusted, you can cut
the outside of the registration mark (cutting area).
Media
Cutting area (same as the area after scanning the registration mark)
MARK TYPE 1
MARK TYPE 3
MARK TYPE 2
MARK TYPE 4
Feed direction of mediaFeed direction of media
Feed direction of mediaFeed direction of media
Origin point
Origin point
Origin point
Origin point