GRAPHTEC CE7000-60 - 2.2 Attaching a Tool

2-5
2.2
Attaching a Tool
Attach a tool (cutter plunger, plotter pen) to the plotter.
Attaching a tool
When mounting the tool in the tool holder, please note the following.
•
Push the tool all the way into the holder until its flange contacts the upper part of the holder and then tighten
the screw firmly.
•
To prevent injury, avoid absolutely touching the tool immediately after the cutting plotter is turned on or
whenever the tool is moving.
It is explained here using cutter plunger as an example.
CAUTION
When pushing the tool holder with your ngers, the blade tip may be protruding. Take care not to cut your ngers.
Supplement
•
When using with half cutting and plotter pen, set the seal in Tool Holder (backward), and when using cutting out (perforated
cut), set the seal in Tool Holder (forward).
•
Half cutting means that only the marking lm is cut out, leaving the backing sheet uncut.
•
Cutting out means that the media is cut out completely.
•
Structure of Marking lm
Marking lm
Backing
sheet
Mounting
1
Loosen the tool holder screw.
Tool holderBracket to hold tool
Bracket to hold tool
Tool holder
Top