GRAPHTEC CE7000-60 - 14.5 Setting the Alarm for Degree of Wear (BLADE WEAR ALARM)

14-7
14.5
Setting the Alarm for Degree of Wear
(BLADE WEAR ALARM)
This function allows to measure the cut distance of pen or cutter blade and use it as a guide to determine when
the cutter blade should be replaced.
BLADE WEAR DETECT ON/OFF, SET BLADE GROUP, ALARM DISTANCE and BLADE WEAR DETECT settings
are required.
Operation
Supplement
Perform the settings in Normal mode.
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/4) is displayed.
3
Press the POSITION ( ) key.
TOOLS SETTING screen (4/4) is displayed.
4
Press the [1] key (BLADE WEAR ALARM SETUP).
BLADE WEAR ALARM SETUP screen is displayed.