GRAPHTEC CE7000-60 - Adjust with 3 POINTS; Adjust with 4 POINTS

6-3
Adjust with 3POINTS
3POINTS adjustment will scan 3 registration marks as shown below, where the adjustment is done measuring
the tilting of the X and Y axes and the distance between the registration marks (horizontal and vertical directions).
This adjustment is called 2-axis adjustment (tilt adjustment).
If the loaded media is tilted as shown below, position of the scanned registration mark is shifted from the position
where it should be. Tilt and distance can be adjusted by comparing these coordinate values.
Feed direction of media
Second registration mark
Tilt
Original registration mark position
Difference in X
First registration mark
Difference in Y
Third registration mark
Tilt
Difference in Y
Original registration
mark position
Difference in X
Adjust with 4POINTS
4POINTS adjustment will scan 4 registration marks in the corners, where the adjustment is done measuring the
tilting of the X and Y axes and the distance between each of the registration marks. It will perform 2 axes warp
adjustment in addition to the 2 axes (tilt) adjustment and distance adjustment, so it can adjust more precisely
than other methods.
Print Cut
Data Image is printed tilted
and warped
GRAPHTEC 2AXES adjusted cut
General 1AXIS adjusted cut