GRAPHTEC CE7000-60 - Setting the Tangential Mode

7-3
Setting the tangential mode
Enabled (Mode 1 and Mode 2) and OFF of the tangential mode can be set individually for each of tool condition
No. 1 to 8.
Operation
Supplement
Perform the settings in Normal mode.
1
Press the [COND/TEST] key.
CONDITION setting screen (1/3) is displayed.
2
Press the POSITION ( ) key.
CONDITION setting screen (2/3) is displayed.
3
Press the [3] key (TANGENTIAL MODE).
TANGENTIAL MODE screen is displayed.
4
Press the POSITION ( ) keys and select the tool condition
number (CONDITION No.).
5
Press the [1] key (MODE1), the [2] key (MODE2), or the [3]
key (OFF) to select the mode.
Supplement
It will return to CONDITION setting screen (2/3)
without changing the settings when you press
the [ESC] key (CANCEL).
6
Conrm the setting and press the [ENTER] key (SET).
Setting will be conrmed and it will return to CONDITION setting screen
(2/3).
7
Press the [COND/TEST] key.
It will return to default screen.