GRAPHTEC CE7000-60 - 7.7 Setting the OFFSET FORCE

7-21
7.7
Setting the OFFSET FORCE
Slight cut operation is performed before the actual cut operation to align the blade toward the cutting direction.
Lower FORCE is necessary compared with the normal cutting, so it is possible to set lower FORCE as an
OFFSET FORCE.
OFFSET FORCE is used to control the rotation of the blade with the tangential mode in addition to control the
blade direction at the beginning of the cut.
Operation
Supplement
Perform the settings in Normal mode.
1
Press the [PAUSE/MENU] key.
MENU screen is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/4) is displayed.
3
Press the [4] key (OFFSET FORCE).
OFFSET FORCE screen is displayed.
4
Press the POSITION ( ) keys to select the Condition No.
Supplement
You can set the range between 1 and 38.
5
Press the POSITION ( ) keys and increase or decrease
the setting value.
Supplement
It will return to TOOLS SETTING screen (1/4)
without changing the settings when you press
the [ESC] key (CANCEL).
6
Conrm the setting and press the [ENTER] key (SET).
Setting will be conrmed and it will return to TOOLS SETTING screen
(1/4).
7
Press the [PAUSE/MENU] key.
It will return to default screen.