2-27
Changing the hold-down force
The CE7000 requires the push roller hold-down force to be set based on the media's width and material type in
order to keep the media in place.
(CE7000-130/CE7000-160 only)
Switching
(1) Raise the media set lever to lower the push rollers.
(2) Use the push roller hold-down force switching lever on the back of the push roller to adjust the center push
roller's hold-down force. It can be set to Strong, Medium or Low (OFF).
(3) When the push roller hold-down force switching lever is lower, it is in Strong mode. When it is upper it's in
Low (OFF) mode.
Hold-down force: Low (OFF) Hold-down force: Medium Hold-down force: Strong
Lever Lever Lever
CAUTION
•
Please switch the hold-down force of the push rollers at both ends to Strong or Medium and keep the same hold-down force.
•
If the hold-down force is changed with the media set lever lowered, the lever operation will be heavier. Always raise the media set
lever and then change itch the hold-down force.
Supplement
•
Low (OFF) of hold-down force is the standard setting for cutting thin lm like car lm.
•
Switch the hold-down force as necessary for different types of media.
To Next Page
Loading...
