A-18
Normal mode
Menu items Setting item Initial value
TOOLS SETTING
(TOOL)
TOOL OFFSET ADJ. –
STEP PASS 1
OFFSET FORCE 7
OFFSET ANGLE 30
DATA SORTING OFF
CONDITION PRIORITY PROGRAM
TOOL UP MOVE
DISABLED
MOVING SPEED AUTO
TOOL UP HEIGHT NORMAL POSITION
BLADE WEAR ALARM SETUP OFF
INITIAL B. ANGLE POSITION 2mm BELOW
ARMS SETTING
(ARMS)
SCAN MODE MODE1
RECOMMENDED SETTINGS –
MARK LINE CHECK –
SENSOR OFFSET ADJ.(X) 0
SENSOR OFFSET ADJ.(Y) 0
MARK AUTO SCAN ON
SENSING SPEED 30cm/s
TEST ARMS SENSOR –
MARK SCAN MODE OFF
AREA PARAMETERS
(AREA)
SCALE 1
ROTATE OFF
MIRROR OFF
AREA SET LOWER LEFT (DEFAULT)
AREA SET UPPER RIGHT (DEFAULT)
EXPAND (DEFAU LT )
MEDIA SETTING
(MEDIA)
PRE FEED FEED LENGTH 1m
AUTO PRE FEED OFF
AUTO PRE FEED FEED LENGTH 1m
PAGE LENGTH 200.0cm (CE7000-40)
500.0cm (CE7000-60/130/160)
INITIAL FEED OFF
FEED SPEED NORMAL POSITION
PANEL CUTTING OFF
DIVIDE LENGTH 100.0cm
TAKE-UP OFF
INTERFACE
(I/F)
HP-GL ORIGIN POINT LOWER LEFT
HP-GL MODEL EMULATED 7586
GP-GL STEP SIZE 0.100mm
RS-232C (SWITCHING SETTING NUMBERS) No.1
RS232C: FORWARDING CONDITION
BAUD RATE /DATA BIT/
PARITY/HARDWIRE HANDSHAKE
RS-232C No.1 : 9600/8/NONE//HARD
RS-232C No.2 : 9600/7/EVEN//HARD
RS-232C No.3 : 9600/8/EVEN/XonXoff
RS-232C No.4 : 9600/8/EVEN/XonXoff
LAN DHCP OFF
LAN IP 192.168.0.1
LAN SUBNET MASK 255.255.255.0
LAN GATEWAY 192.168.0.254
COMMAND ':',';' ENABLED
COMMAND 'W' TOOL UP
CIRCLE RESOLUTION DEFAULT
ADVANCE
(ADV.)
MOVE STEP 0.1mm
LANGUAGE SELECTION Select when initially turning on power
LENGTH UNIT Select when initially turning on power
BEEP FOR KEY OPE. ON
POSI. KEY SPEED + SLOW KEY 1cm/s
POSI. KEY SPEED 10cm/s
PAUSE/MENU KEY SETTING PAUSE
LCD CONTRAST 0
MEDIA SENSOR ENABLED
PUSH ROLLER SENSOR ENABLED
FAN POWER NORMAL POSITION
TEST
(TEST)
NO SETTINGS –
To Next Page
Loading...
