GRAPHTEC CE7000-60 - Page 270

13-16
When using Graphtec Pro Studio
1
Click on the registration mark on the design screen.
Feed direction of media Feed direction of media
MARK TYPE 1 MARK TYPE 2
Registration mark Registration mark
2
Press the "Options" on the "DesignCentral" screen.
3
The "Graphtec Mark Options" screen is displayed.
Check the "Use Barcode" and select the "Standard" from
the "Barcode Type". Press the “OK”.
4
Press the on the "DesignCentral" screen.
Bar code is created on the design screen.
G0100SYAA
G0100SYAC
Feed direction of media Feed direction of media
MARK TYPE 1 MARK TYPE 2
Bar code Bar code