GRAPHTEC CE7000-60 - Page 304

15-4
Symptom Possible Cause Solution Reference
• Tool condition changes. Setting of the priority is set to
PROGRAM.
Change the setting of the priority to
MANUAL.
Priority of Tool Condition
Selection (CONDITION
PRIORITY)
[ENTER] key is not pressed
after changing the TOOL
CONDITION.
Check the TOOL CONDITION again. Setting the Tool Condition
• Media travels tilted. Media is loaded tilted. Reload the media. Loading Media (Paper or
Making Film)
Media is slipping. Perform pre feed once and make
impression to make it harder to slip.
Pre Feed of Media
(Paper or Marking Film)
Changing of the hold-down
force of the push roller is not
suitable for the media.
Please set a media suitable for
changing the hold-down force.
Changing the Hold-down
Force
• It does not become specied
length. (Slight distance
error)
Media is slipping. Make the speed slower.
Reduce the moving speed.
Perform feeding.
Setting the Tool Condition
Pre Feed of Media (Paper or
Marking Film)
Setting the Tool Up Speed
Distance adjust value is not
correct.
Perform distance adjust. Setting the Distance Adjust
• "LOAD MEDIA!" is displayed
even if the media is set and
media set lever is moved
up.
Media is close to transparent
and media sensor makes
false recognition. (This may
happen depending on the
media.)
Transparent media cannot be
detected. DISABLE the media sensor
and set the cut area when this kind of
media is used.
Enabling/Disabling the
Media Sensors (MEDIA
SENSOR)
Setting Cutting Area
Media sensor malfunctions
with strong scattered
reection.
Move the position of the light source.
Make is so no direct sunlight shines.
There may be defective in the
operation of the media set
lever sensor.
Contact your sales representative or
the Graphtec call center.