FC9000-UM-251-9370 31
9 TROUBLESHOOTING
9.6.6 Warning Messages
Error
code
Error Display Cause Solution
W06001
Cross cut function cannot
operate to the sheet media.
Load the roll media.
W06002
Cross cut function cannot
operate when the media is
loaded to the front loading
mode.
Load the media with the rear loading
mode.
W06003
Cross cut function cannot
operate without loading the
media.
The media sensor and the
push roller sensor of detecting
setting are disabled.
Load the media.
Enable the detection of the media
sensor and the push roller sensor.
W06004
Cross cut function cannot
operate when the push roller
sensor is disabled.
Enable the detection of the push
roller sensor.
W06005
Cross cut function cannot
operate when the media sensor
is disabled.
Enable the detection of the media
sensor.
W06006
Warning of cross cut operation.
W06007
CONDITION No. that has
selected pouncing tool as the
tool number setting can only
set TOOL 1.
Select TOOL 1.
W06008
When command is set to
auto, the DUMP mode is not
available.
Select the command setting to the
HP-GL or the GP-GL.
W06009
When it is panel cutting, copy
and origin point settings cannot
operate.
The copy mode and the origin point
settings cannot operate in the panel
cutting mode.
To Next Page
Loading...
