GRAPHTEC FC9000-140 - Printing the Setting of the Plotter

FC9000-UM-251-9370 35
9 TROUBLESHOOTING
9.7.2 Printing the Setting of the Plotter
Condition setting list can be printed when you need to check the current setting of the plotter.
Operation
(1) Set a paper larger than A3 size.
(2) Set the pen tool to the tool carriage and select the condition where the pen tool is set.
(3) Press the PAUSE/MENU key to display the menu below.
(4) Press the Left position (
t
) key (TEST) to display the menu below.
(5) Press the F1 key (CONDITION LIST) to display the menu below.
(6) Press the F1 key (DONE 1/2) or the F2 key (DONE 2/2).
Message to conrm tool position is displayed.
(7) Move the tool position to print start position by using the POSITION key.
(8) Press the ENTER key to start printing the condition list.
It will return to READY status when the printing is completed.