GRAPHTEC FC9000-140 - Replacing the Push Roller Assembly

FC9000-UM-251-9370 7-38
7 DISASSEMBLY AND REASSEMBLY
7.2.17 Replacing the Push Roller assembly
How to detach the Push Roller assembly
(1) Detach the right side cover (Refer to subsection 7.1.1.).
(2) Remove the M3L6 binding head screw holding the cam sensor board.
Cam sensor board
M3L6 binding head screw
(3) Detach the cam sensor board.
(4) Remove the two M4L8 binding head screws holding the cam sensor dog, and then detach it from the
cam shaft.
Cam sensor dog
Cam shaft
M4L8 binding head screw
(5) Remove the two M3L10 TP screws holding the cam set lever, and then slide it to the right side as shown
in the picture below.
Set lever
M3L10 TP screw