GRAPHTEC FC9000-140 - Replacing the Cam Sensor Board

FC9000-UM-251-9370 7-25
7 DISASSEMBLY AND REASSEMBLY
7.2.10 Replacing the Cam Sensor board
How to detach the cam sensor board
(1) Detach the right side cover (Refer to subsection 7.1.1.).
(2) Remove the M3L6 binding head screw holding the cam sensor board.
Cam sensor board
M3L6 binding head screw
(3) Disconnect the exible cable from the cam sensor board.
How to reinstall the cam sensor board
(1) Reattach the cam sensor board in the reverse order in which it was detached.
(2) Conrm the dog of cam is not touching to the sensor of cam sensor board after cam sensor board was
attached.
Cam sensor dog
Conrm the dog of cam sensor is not touching to the
sensor here.
Cam sensor
(3) Conrm the wiring for cam sensor exible cable (Refer to subsection 7.4.).
(4) When the cam sensor board was replaced, backup the adjustment values to the cam sensor board from
the main board.