GRAPHTEC FC9000-140 - Attaching a Tool

FC9000-UM-251-9370 3-3
3 PARTS NAMES and FUNCTIONS
3.2 Attaching a Tool
Attach a tool (cutter pen, plotter pen) to the plotter.
Attaching a Tool
When mounting the tool in the tool holder, push the tool all the way into the holder until its ange contacts
the upper part of the holder and then tighten the screw rmly. To prevent injury, avoid touching the tool
immediately after the cutting plotter is turned on or whenever the tool is moving. It is explained here using
cutter pen as an example.
(1) Loosen the pen holder screw.
(2) While pushing the tool holder in the upward direction, push the tool all the way into the holder until its
ange contacts the upper part of the holder.
• When pushing the tool holder with your ngers, the blade tip may be protruding. Take care not to cut
your ngers.
For half cutting
(backward)
For cutting out
(forward)
Tool holder
Bracket to hold tool
Flange