FC9000-UM-251-9370 3-2
3 PARTS NAMES and FUNCTIONS
Rear View
Push roller hold-down force switching lever
Media set lever
Stock rollers
Media stocker
AC line inlet
USB interface
Stopper
Stand
Basket
USB memory
port
Optional RS-232C interface
for Japanese and Chinese
model
Network interface (LAN)
AC line inlet: ....................... Inlet where the power cord is connected.
Push roller hold-down force switching lever:
............................................. Used to switch between the three pinch roller forces.
Media stocker:.................... Used to carry roll media and ensure its proper rotation.
Stock rollers: ...................... A media roll is placed on these rollers.
USB interface connector:
............................................. Used to connect the plotter to the computer with a USB interface cable.
Network interface connector:
............................................. Used to connect the plotter to the computer with a network interface cable.
Optional RS-232C interface connector:
............................................. Used to connect the plotter to the computer with an RS-232 serial interface
cable.
This option is for the Japanese and Chinese model only.
USB memory dedicated port:
............................................. The port that is used only for the USB memory.
Stand: .................................. Stand for the plotter.
Basket: ................................ Used to receive Media and removing static electricity from media.
To Next Page
Loading...
