GRAPHTEC FC9000-140 - Page 21

FC9000-UM-251-9370 3-4
3 PARTS NAMES and FUNCTIONS
(3) Make sure that the tool bracket is engaged on the tool’s ange, and then tighten the screw.
Bracket to hold tool
Flange
Attaching a Pen to the Two-Pen Holder (Option)
The two-pen holder is a factory-installed option, and cannot be retrotted.
(1) Loosen the pen holder screw.
Top view
Tool holder
Tool holder
Bracker to hold tool
Bracker to hold tool
(2) While pushing the pen holder in the upward direction, push the pen all the way into the holder until its
ange contacts the upper part of the holder.
• When you push the pen holder with your ngers, the blade tip may be protruding. Take care not to cut
your ngers.
For half cutting
(backward)
For cutting out
(forward)
Tool holder
Top View
Bracker to hold tool
Flange