GRAPHTEC FC9000-140 - Page 22

FC9000-UM-251-9370 3-5
3 PARTS NAMES and FUNCTIONS
(3) Make sure that the pen bracket is engaged on the pen’s ange, and then tighten the screw.
Bracket to hold tool
Flange
Attaching a Plotting Pen to the Pen Station
(1) Open the pen-hold mechanism on the pen station, and then attach a pen.
Holding part
(2) Make sure that the bracket of the pen station is engaged in the upper groove of the pen.
Attach the pen with the upper groove of pen.
(3) Close the pen-hold mechanism on the pen station to hold the pen in place.
• Do not leave a pen attached to the pen station for a long period of time, as the pen tip will dry up and
make it unusable.
• To store the pen, remove it from the pen station and replace its protective cap.