GRAPHTEC FC9000-140 - Page 77

FC9000-UM-251-9370 7-39
7 DISASSEMBLY AND REASSEMBLY
(6) Remove the two M3L10 binding head screws holding the right and the left cam shaft holder.
Cam shaft holder
M3L10 binding head screw
(7) Mark the position of push roller stopper as shown in the picture bellow, and then loosen the screw
holding the push roller stopper.
FC9000-75 FC9000-100/140/160
Mark the position of stopper here.
Stopper screw
(8) Slide the push roller stopper to the left side of notch of Y rail.
FC9000-75
FC9000-100/140/160
Slide the stopper to here.
Notch of Y rail
(9) Conrm the position of set-lever is the unloaded position.
(10) Pull the cam shaft at the right side (left side from the rear view.), until the left side of notch of Y rail.
Cam shaft
Pull out the cam shaft until this position.
Don’t push out the cam shaft from
this side, otherwise the exible cable
damages by the right side of cam shaft.