FC9000-UM-251-9370 4-5
4 OPER ATIONS
Contents of Operation from Menu Screen
MENU screen
Contents of the operation and settings that is displayed in MENU screen with [PAUSE/MENU] key is as
following:
[1] (TOOL): ........... Make the setting for the operation of the tool.
[2] (ARMS): ........... Make the settings and operation to position the tool and media, such as automatic
scanning of the registration marks by the ARMS.
[3] (AREA): ........... Make the settings for area, magnification, rotation, reverse, etc., of the cutting.
[4] (MEDIA): ......... Make the setting of the condition for the media.
[p] (I/F): ............... Make the settings of the condition for the interfacing with the control computer.
[q] (ADV): ............ Make the settings of the conditions for the basic operation of the plotter, such as display
language, unit of the measurements, sensor, etc.
[t] (TEST): ........... Does the operation necessary for maintenance, such as self diagnostic test or printout of
the condition settings list.
[u] (LINK): ............ Make the setting of the data link.
PAUSE/MENU: ..... It will close the MENU screen and return to default screen.
Contents of Operation from COND/TEST key
CONDITION screen (1-3)
Tool conditions are set in the setting screens displayed by the [CONDITION] key.
Up to 8 CONDITION settings can be saved with different settings in numbers 1 through 8.
COND/TEST: ........ It will clear the CONDITION screen and return to default screen.
To Next Page
Loading...
