GRAPHTEC FC9000-140 - Page 73

FC9000-UM-251-9370 7-35
7 DISASSEMBLY AND REASSEMBLY
How to reinstall the drive roller shaft assembly
(1) Reattach in the reverse order in which it was detached.
(2) When the drive roller shaft assembly is installing, conrm the position of bush as shown in the picture
below.
FC9000-75
FC9000-100
FC9000-140
FC9000-160
Drive roller shaft
assembly
Bush
Bearing
Grid roller
Bush Bearing
(3) When the X drive pulley is installing to the drive roller shaft assembly, tighten the four M3L4 set screws
while pushing the drive pulley and the drive roller shaft assembly to the following direction.
Drive roller shaft assembly
X drive pulley
(4) Spread a suitable quantity of Loctite 222 on the four M3L4WP set screws holding the X-drive pulley.
(5) Perform the X-drive belt tension adjustment (Refer to subsection 7.3.2.).
(6)
Reattach the other parts in the reverse order in which they were detached.