GRAPHTEC LABELROBO LCX603 - Setting the Frame Cut

LCX603-UM-651-9370 2-92
2 Setup
2.26 Setting the Frame Cut
Thissettingtouseornotuseframecut(outlinecutting).
Whenframecutissetto"ON",cuttheoutlineconformingtotheindicatedplottingareaintheprinterdriver
whenprinting/cutting.
Frame Cut
Residueremovalmaybecomedifcultintheseparatorunitdependingonthecongurationofthelabels
beingproducedorlabelmaterialtype(25μmmaterialsorpaper-typematerials).Insuchcasesyouwill
havetopeelwithyourhands,butinsertacuttinglineintheoutlineofthesheetandremoveexcessresidue
intheseparatorunit.Horizontalcuttingafterwardwillbecomesmoothasaresult.
Feeding
direction
Start mark
Frame cut
Insequencenumbercreationapplicationsoftware,etc.,thereisafunctionthatlaysoutsequencenumbers
orbarcodesinthesheetbydesigningsinglelayerlabels.However,theyareconverselynotableto
indicateacuttinglineforoutlinecutting.Assuch,theLCX603willmatchthepapersizeandcuttheoutline.
How to set the frame cut
Conrmtheframecutsettingissettothe“OFF”thistime.
(1) PresstheLOCALKeyinREADYstatus,thefollowingmenuisdisplayed.
PR I N TER M ENU>
C U T TER M ENU>
O U TPU T ALL>
(2) PresstheF1Key(PRINTMENU),thefollowingmenuisdisplayed.
C OPY>
D A TA C L EAR>
C OND I T ION>
1/4