GRAPHTEC LABELROBO LCX603 - Installing the Ink Ribbon to the Ink Ribbon Cassette

LCX603-UM-651-9370 2-41
2 Setup
2.13.3 Installing the Ink ribbon to the Ink Ribbon Cassette
(1) Installtheinkribbonstotheribboncassetteswhicharepreparedtotheprintingtest.
(2) InstalltheRESINinkribbon(RP120-B-R4A)tothetopribboncassette(head3).
(3) Pullouttheinkribboncassettefromtheribbonstockergentlyasshowninthepicturebelow.
Step 1
While pressing the stopper lever
of center back, pull the ribbon
cassette gently.
Step 2
The head pressure selector plate for the RESIN and the Semi-RESIN ink ribbons
Therearetwotypesofinkribbons:RESINandSemi-RESIN.
RESIN(Resin-type).......................RP120-***
Semi-RESIN(Wax-type)...............WD120-***
Theheadpressureselectorplatepositionhavetobeselectedbytheinkribbontype.
RESIN
Semi-R
RESIN
Semi-R
Step 1
Press the lever to release
the head pressure selector plate
Lever
Head pressure
selector plate
Ink ribbon cassette
Step 2
Slide the head
pressure
selector plate