GRAPHTEC LABELROBO LCX603 - Loading Media to the LCX603

LCX603-UM-651-9370 2-26
2 Setup
2.12 Loading media to the LCX603
Pulloutthemediasetbythemediastockerandsetwhenreadytouse.
Withtheexceptionofreplacingmedia,donotpulloutthemediastockerfromtheLCX603.
Media Route
Themediaisloadedasshowninthepicturebelow.
Feed Roller
Laminate gude bar
Media exit
Press Roller
Dancer roller 2 Dancer roller 1
Cutter unit
Media stocker
How to load the media to the LCX603
(1) TakeouttheMediaassistfromtheaccessorybox,andthensettheMediaAssisttotheLCX603.
UsetheMediaassistwhenloadingthemediatotheLCX603,otherwisemediajams.
(2) Openthefrontdoor.