GRAPHTEC LABELROBO LCX603 - Adjusting the Print Head Position

LCX603-UM-651-9370 2-68
2 Setup
2.19 Adjusting the print head position
Thisadjustmentshouldbeperformedafterthedistanceadjustment.
Headpositionadjustmentoccursdependingonthetypeandthicknessoftheutilizedmedia,andthe
head(ribbon)positionmisalignmentiscorrected.Theheadpositionadjustmentvalueisenteredasa
measurementofthelinesegmentmisalignment.
Theadjustmentpatternisprinted,andthecorrectionvalueisenteredintheheadpositionadjustment.
Theadjustmentpatternoutputstwolayers.Measuretherstlayerandinputthecorrectionvaluefor
Head1PositionAdjustment.MeasurethesecondlayerandinputthecorrectionvalueforHead2Position
Adjustment.
The130mmwidthmediahavetobeinstalledwhenperformingtheprintheadspositionadjustment.
Andtheinkribbonshavetobeinstalledforallprintheads.
Adjustment Pattern Instructions
Y
X
First page
Second page
Y
X
Printed with head 3
Printed with head 3
Printed with head 2
Printed with head 1
Feeding direction
Feeding direction
Wrinkle
prevention
lines
Wrinkle
prevention
lines
Measure the gap between cross mark to the vertical line.
And measure the gap between cross mark to horizontal line.
Measure the gap between cross mark to the vertical line.
And measure the gap between cross mark to horizontal line.