GRAPHTEC LABELROBO LCX603 - Installing the LCX603 on the Table

LCX603-UM-651-9370 2-5
2 Setup
2.2 Installing the LCX603 on the Table
(1) ConrmtheinstallationspaceasshowninthepicturebelowbeforeinstallingtheLCX603.
 Leavesufcientspaceforoperationsinfrontofandbehindtheprinter.
500mm
50mm
1000mm
500mm
(2) WheninstallingtheLCX603onatable,pleaseuseadurable,solidtablewithasurfacelargerthan
1000mm×400mm.
(3) Installinaatlocation.
(4) TheweightofLCX603isabout80kg,thetablemustbestrongenoughtoputtheLCX603.
(5) HavethebottompartoftheLCX603andthenputtheLCX603onthetable.
Notes for installation of the LCX603
 Whensettinguponadeskorworktable,makesuretherearetwopeopletocarryoutthe
task.
WhencarryingtheLCX603,havethebottompartoftheLCX603.
DonotusethehandleinthemediastockersectionwhenliftuptheLCX603,otherwisethe
LCX603willbreak.
Handle
(6) Adjustthefourlevelers(adjusters)sothattheLCX603isat.