GRAPHTEC LABELROBO LCX603 - Installing the Cutter Pen to the LCX603

LCX603-UM-651-9370 2-19
2 Setup
2.9.2 Installing the cutter pen to the LCX603
Thetools(cutterpen)aresetinthisdevice.
Wheninstallingthecutterpeninthetoolholder,fullyinsertthecutterpensectioninthebeloworder
untilitbumpsintothetopsideofthetoolholder.Afterthecutterpenisinstalled,tightenthescrew.
Furthermore,donottouchthepentipwhenthepowerhasbeenturnedonorduringoperation.
 Whenhandlingthecutterblades,takefullcarenottocutyourhands.Whenpushingup
thetoolholder,takefullcarenottoinjureyourngersonthecutterblades.
(1) Loosenthetoolholderscrew.
(2) Whilepushingupthetoolholder,fullyinsertthecutterpensectionuntilitbumpsintothetopsideof
thetoolholder.Setthebrackettoholdtooltocovertheangesectionofthecutterpen.
Flange
Bracket to hold tool
Flange
Bracket to hold tool
(3) Whenthecutterpenisset,setthebrackettoholdtooltocovertheangesectionandtightenthe
screw.
Flange
Bracket to hold tool
Correct position of bracket
Correct position of bracket Incorrect position of bracket
Good Bad